I have two 1.5" pipes going to my pump on from a bottom drain and another from a skimmer. I want to connect these to a three port jandy valve to be able to adjust suction to each. Can I put a suction on the "inlet" side of that valve? Meaning "T" is the valve, and the bottom of the "T" is labeled "inlet".
1.5" T 1.5"
2" Pump Suction
Is this setup possible?
So according to jandy the valve works opposite what I want.
1.5" T 1.5"
2" Outlet from pump or filter
- - - Updated - - -
We'll that didn't publish right. The arrows on the line below the "T"s are suppose to be directly under the "T"s.
1.5" T 1.5"
2" Pump Suction
Is this setup possible?
So according to jandy the valve works opposite what I want.
1.5" T 1.5"
2" Outlet from pump or filter
- - - Updated - - -
We'll that didn't publish right. The arrows on the line below the "T"s are suppose to be directly under the "T"s.