I have just installed my new Si+45 CircuPool Si45-Plus Salt System Voltage: 110v With plug. Running into several issues and need your help.
1. Just installed it yesterday and ran it several hours. I went back to check the until and touched the exterior metal box that was super hot to the touch. Yes the until was in direct sunlight, but this was way more than that. I know this system can come as 110v or 240v. Could the system be setup as 240v and be the reason for until heating up? I have attached a picture of setup.
2. During the running time and reason I went out and checked the unit because there was a loud vibration. The unit was installed on exterior of home and virbation was amplified on the inside. I removed the metal face plate and vibration went away. Has any one run into this same issue? Anything I can use help stop the vibration?
3. When the unit was turned on I noticed the LED lights switched up. From the manual normal operation should be set to "on" and super chlorinate to "auto". I have attached two pictures of how these are switched for some reason. Any one know how to fix this or would this be a question for manufactur?
http://www.troublefreepool.com/attachment.php?attachmentid=29785&d=1401113900&thumb=1&stc=1
Thanks inadvance for your help and/or feedback.
1. Just installed it yesterday and ran it several hours. I went back to check the until and touched the exterior metal box that was super hot to the touch. Yes the until was in direct sunlight, but this was way more than that. I know this system can come as 110v or 240v. Could the system be setup as 240v and be the reason for until heating up? I have attached a picture of setup.
2. During the running time and reason I went out and checked the unit because there was a loud vibration. The unit was installed on exterior of home and virbation was amplified on the inside. I removed the metal face plate and vibration went away. Has any one run into this same issue? Anything I can use help stop the vibration?
3. When the unit was turned on I noticed the LED lights switched up. From the manual normal operation should be set to "on" and super chlorinate to "auto". I have attached two pictures of how these are switched for some reason. Any one know how to fix this or would this be a question for manufactur?
http://www.troublefreepool.com/attachment.php?attachmentid=29785&d=1401113900&thumb=1&stc=1
Thanks inadvance for your help and/or feedback.