Hello All,
I know this is probably a dumb question but I just wanted to ask and double check to make sure I'm following the Recommended Levels for my pool. I have a SWG, Inground, Wet Edge Finish (Pebble Tec) so I'm assuming that if I stick to the guidelines for SWG Plaster, I'm golden correct? Or do you guys think I should make any tweaks for that type of finish? Currently, my levels are:
FC: 5
Ph: 7.5
TA:70
CYA: 70
CHA: 250 (going to bump it to 300)
Salt: 400 ppm above factory recommended
Thanks for your help.
I know this is probably a dumb question but I just wanted to ask and double check to make sure I'm following the Recommended Levels for my pool. I have a SWG, Inground, Wet Edge Finish (Pebble Tec) so I'm assuming that if I stick to the guidelines for SWG Plaster, I'm golden correct? Or do you guys think I should make any tweaks for that type of finish? Currently, my levels are:
FC: 5
Ph: 7.5
TA:70
CYA: 70
CHA: 250 (going to bump it to 300)
Salt: 400 ppm above factory recommended
Thanks for your help.
