I'm upgrading my Hayward 2100 control to a ProLogic PL-P-4. The control is ordered and I'm doing all my reading to get ready for the installation. It's pretty basic pool/spa setup: main pump, cleaner pump, heater, lights and blower.
Does anybody have a wiring job that they are particularly proud of? Let's see some pics!
I'm also replacing the whole board that the panel is mounted on since the old one is all wobbly. I'd also like to see pics of your entire set up if you think it's particularly nice. I'm mainly focused on the electrical since I'm not planning on rerouting any of the plumbing.
Are there any pitfalls to watch out for? Anything you wish you'd done differently?
Does anybody have a wiring job that they are particularly proud of? Let's see some pics!
I'm also replacing the whole board that the panel is mounted on since the old one is all wobbly. I'd also like to see pics of your entire set up if you think it's particularly nice. I'm mainly focused on the electrical since I'm not planning on rerouting any of the plumbing.
Are there any pitfalls to watch out for? Anything you wish you'd done differently?