Help With SWG Display

[loom02]

Hi, first off I'm New to the forum, But I have "I hope" an easy question. I have a Aqua Right SWG for 3 months now, the inspect cell light started flashing
so I inspected the cell (was clean) so I put it back together and reset the light by holding the diagnostic button down till it stopped.
But now the display shows I believe in metric instead of English it used to read the salinity in xxxxppm but now it shows x.xx. would someone
know how to change it back.
Thanks

 

[jblizzle]

Welcome to TFP!!!

Well according to the manual (you have one right? ... is not go HERE) to switch from metric back to English units:

1. Slide the Main Switch to the "Auto" position.
2. Push the Diagnostic button repeatedly until "ºF" appears on the display.
3. Slide the Main Switch from "Auto" to "Super Chlorinate" and back to "Auto".
4. Push the Diagnostic button to exit.

 

[loom02]

I have a manual and that's what it says to do but there is no "ºF" that comes up no matter how many times I push the button. Is there something I'm doing wrong?

 

[jblizzle]

Does a "C" come up? I though you were already in metric mode and need to do it again to get back to English units.

 

[loom02]

No "C" comes up either. I tried turning power to the unit completely off waiting a few minutes
But nothing.

 

[jblizzle]

So list all the displayed numbers you see in order.

 

[loom02]

#1 3.20
#2 32
#3 23.9
#4 4.03
#5 72p
#6 -3.20
#7 AL-1
#8 r 1.58
#9 T-9

 

[jblizzle]

The 32 is the degrees C ... so do the procedure on that display

#1 is the average salt grams/L
#5 is the instant salt grams/L

 

[loom02]

That was it!
Thanks