help - wiring new pump motor

[run53]

In the middle of installing a new UST10172 motor on a pump. Ready to hook it up but there are no wiring diagrams provided. I know these are usually from the factory at 230V but I have a 115v installation.

Anyone know how to change this? It's not obvious to me by looking at the existing wiring and the old motor is just a bit different.

Thanks

 

[Charlie_R]

Does the dataplate on the new motor indicate it can be run on 120/240? If not, then you will have to run a new line from a 240 (two pole) circuit breaker.

 

[bobodaclown]

There's no diagram on the motor?
Try this link: http://www.bestbuypoolsupply.com/media/motormanual.pdf

 

[run53]

You got it! The diagram was right on the motor. Pump could be run in either 230 or 115 mode and all I had to do was turn a lever on the motor. Pump is now up and running fine.

Thanks for helping!