I just did a full set of test on my fill water and here are the results
Fill Water Results
pH-8.2+(Very dark purple)
FC-.5
CC-1.5
TC-2
CH-25 (Used a 10 ml sample instead of 25. One drop caused it to go from red to blue)
TA-400
CYA-0
My pool is approx 13,000 gallons. I usually have to add 1-2 inches of water when I do. Based off of the results, how can I expect it to mess with the water already in the pool.
Say for example my pH level is 7.4 and I add 1-2 inches of water, would I see any change in my pH level after the water has been added?
If there is a change, is there a percentage of change I should see?
Thanks in advance
Fill Water Results
pH-8.2+(Very dark purple)
FC-.5
CC-1.5
TC-2
CH-25 (Used a 10 ml sample instead of 25. One drop caused it to go from red to blue)
TA-400
CYA-0
My pool is approx 13,000 gallons. I usually have to add 1-2 inches of water when I do. Based off of the results, how can I expect it to mess with the water already in the pool.
Say for example my pH level is 7.4 and I add 1-2 inches of water, would I see any change in my pH level after the water has been added?
If there is a change, is there a percentage of change I should see?
Thanks in advance