Does anyone know if a digital water pressure filter gauge is offered? Seems like an easy thing to do and would be nice to tie it into the iaqualink. Set pressure start point at cleaning and monitor it with alarms and backwash/cleaning thresholds on the software.
Digital filter pressure gauge
- Thread starter Heinsite
- Start date
You can use any standard water rated pressure gauge, most are male 1/4 inch NPT, the gauges sold to the pool market tend to be low quality and don't last but a couple of years I am sure you could spend hundreds if not thousands of dollars on digital gauges.
A quick ebay search found this potential one with the right general PSI range, etc. http://www.ebay.com/itm/New-Ashcroft-0- ... 41725aaae8
I assume it is water rated, but did not dig up the specs
this could likely be done with cheaper pressure switches
A quick ebay search found this potential one with the right general PSI range, etc. http://www.ebay.com/itm/New-Ashcroft-0- ... 41725aaae8
I assume it is water rated, but did not dig up the specs
this could likely be done with cheaper pressure switches
What type signals does the aqualink handle? There are many pressure transducers on the market that would easily work but they are usually 4-20 mADC outputs.
I'm not sure on outputs, but i know you can run low voltage lights, sprinkler systems, etc on the iaqualink/jandy Rev. R board. There are a few extra two pin plug in slots.