After a rough day I finally have the Liquidator running, or so it appears. I don't have any major bubbles in the system but I do have what I would call soda fizz in the lines here and there. I see it in the actual tank as well, so I'm hoping that's not a big deal.
I've taken my reading for tonight and will check it again tomorrow. Unfortunately have to leave for the week tomorrow pm so either I'll hope it's running well or shut it down and have the wifey half bottle it every day while I'm gone.
But my real question is, all the leaking like a sive air turnout out to be the connections on the John Guest check valve (the 1 of 3 that I ordered on line that showed up... apparently the packagers can't differentiate between the numbers 1 and 3). I had so much air my pump wouldn't actually pull water. Went and got some additional 3/8 hose and mounted that directly from the pump to each device (liquidator out, hayward needle, volume meter, check valve) to find the problem. With some coaxing the JG check valve now appears to be seated and the pump is huming nicely.
However, since only one valve came, I just have a straight line from my tap to the Liquidator on the return. Which begs the question, what is the point of the check valves? I run my pump 24/7 so I don't have any worry about air backing up when it's not on. The return side seems to be humming along. When I was testing each connection it was working beautifully, including no soda fizz, without the check valve. So what's the point? Can I run both sides without it? Seems like one less thing, which I'm always up for one less thing.
Thoughts?
I've taken my reading for tonight and will check it again tomorrow. Unfortunately have to leave for the week tomorrow pm so either I'll hope it's running well or shut it down and have the wifey half bottle it every day while I'm gone.
But my real question is, all the leaking like a sive air turnout out to be the connections on the John Guest check valve (the 1 of 3 that I ordered on line that showed up... apparently the packagers can't differentiate between the numbers 1 and 3). I had so much air my pump wouldn't actually pull water. Went and got some additional 3/8 hose and mounted that directly from the pump to each device (liquidator out, hayward needle, volume meter, check valve) to find the problem. With some coaxing the JG check valve now appears to be seated and the pump is huming nicely.
However, since only one valve came, I just have a straight line from my tap to the Liquidator on the return. Which begs the question, what is the point of the check valves? I run my pump 24/7 so I don't have any worry about air backing up when it's not on. The return side seems to be humming along. When I was testing each connection it was working beautifully, including no soda fizz, without the check valve. So what's the point? Can I run both sides without it? Seems like one less thing, which I'm always up for one less thing.
Thoughts?