Yesterday afternoon, a Check System Error “Filter Mains Voltage High” (see attachment) occurred. I turned the filter breaker off and on and the error cleared. It happened twice more and I once reset the Main breaker to the primary house power panel to clear it. Currently, it’s back in the check system error state. The system was installed in October 2011 for a new pool.
I wasn't able to find any troubleshooting information on this error. Is there something I can do to root cause or reset so the error will permanently go away? All other electrical components in the house and for the pool seem to be operating without issue.
Here are the components and software versions:
Filter: Hayward SwimClear C4030
Hayward Pro Logic Automation:
Main Software Revision 4.30
Webster Firmware 01.00
Filter Display Software r2.56
Filter Drive Software r1.02
RF Base Software r3.00 ID:ECF0
I'm new to the forum and I apologize if I posted to the wrong topic.
Thank you for your help and advice.
I wasn't able to find any troubleshooting information on this error. Is there something I can do to root cause or reset so the error will permanently go away? All other electrical components in the house and for the pool seem to be operating without issue.
Here are the components and software versions:
Filter: Hayward SwimClear C4030
Hayward Pro Logic Automation:
Main Software Revision 4.30
Webster Firmware 01.00
Filter Display Software r2.56
Filter Drive Software r1.02
RF Base Software r3.00 ID:ECF0
I'm new to the forum and I apologize if I posted to the wrong topic.
Thank you for your help and advice.