Aqua rite display

[sunny8088]

I pressed diagnostic button after I clean the CELL

The first display used to be 3300 for salt , now it shows as 3.30 , dont have clue how to reset it back

 

[Mike_W]

Does your water temp on the Aqua Rite now indicate degrees "C" vs degrees "F"? If so you are in the metric display mode. Do this to get out of metric:

1. Slide the Main Switch to the "Auto" position.
2. Push the Diagnostic button repeatedly until "ºF" appears on the display.
3. Slide the Main Switch from "Auto" to "Super Chlorinate" and back to "Auto".
4. Push the Diagnostic button to exit.

Here's a link to the Aqua Rite manual from Hayward.

http://www.hayward-pool.com/pdf/manuals/AquaRiteAQR.pdf

Mike

 

[sunny8088]

I dont see the "0F" display on my LCD

 

[Mike_W]

The display nominally shows salt concentration. If you push the diagnostic button once, it will indicate water temp (it must be on and generating). It doesn't show the units, degrees C or F. If your water temp in Florida is, say somewhere between 60 and 80, it is F. If it is 28 or less, either you are in north Alberta or it is displaying in degrees C.
Mike

 

[sunny8088]

Mike , will try out today. Thanks