AQUA LOGIC GOLDLINE CONTROLLER

[oscottkay]

I have a Aqua Logic controller and now it's not generating any chlorine. I had salt cell checked and it is fine. Controller is showing:
Chlorinator off No cell power
Salt level 0000
check system no cell power 2
reset light is on

Anyone have any ideas ast to what could be the issue? The pcb board looks OK visually

Thanks Scott

 

[Christian]

Hey Scott, try pulling out the PCB board and looking at the back of it. There is a spot on the back of the board that frequently burns out and if so you should be able to see the damage.

 

[Just-a-PB]

Go Here.
http://www.nocellpower.com/

 

[oscottkay]

Thanks Christian I will try pulling the board in the morning.

 

[oscottkay]

OK just as you suggested. When I looked at the back of the pcb borad it was burned. So I soldered and I did get readings at first. Now it says salt amps to high chlorinator off. It always seems to read about 800 ppm more than Leslie. Is there something I can do short of dumping water to lower salt readings?

 

[Just-a-PB]

What is your actual salt amount in your pool?

 

[oscottkay]

The actual salt is 3100 per Leslie the controller shows 3900 to 4000