Installation question

[texfed]

I recently bought a new Autopilot DIG-220 to replace an old one that died. I'm installing the new one, and step 3 of the instructions says to loosen the thumbscrews of the unit cover, slide off the outer housing, and disconnect the 3 plugs that connect to the display mounted inside the cover. My new unit only has 2 plugs connected to the display. Is this a typo in the instructions or am I missing a plug? Thanks

 

[Poolsean]

There WAS another connector plug that is used specifically for interface to an Electronic Control System, such as an Intellitouch or Aqualink type system. If you need this kit, let me know. However, we usually do not recommend connecting it in this fashion as you will loose some AutoPilot functionality, such as the salt addition calculation, freeze protection, and temperature compensation.

 

[texfed]

Sean,

Thanks for the quick response.