I went to the pool store last week because the salt level was low.They tested the water and sure enough it needed stabilizer and salt. i had allready added the acid. We have had alot of rain so i know that it needs stabilizer and then salt. added both and let it go for a few days. I went and looked and the numer was 2500 again. I know that it cant possibly need morestabilizer and salt.
The display said 2500 but there were not any lights lit at all. I starred at it for a few minutes and heard a click and the lights came on for 10 seconds and then went off again. I opened up the box and couldnt see any burn or char marks and i did not see the that the diode was cracked or burnt. I inspected the cord that goes to the SWG and that looks fine and the SWG is only 2 years old.
when i go to the diagnostics:
cell voltage.... 0.04 climbs to 18.0....light come on and then the votage drops back to 0.04 this all occurs after i cycle through the diagnostics, because it defaults back to the 2500 after a minute.
amps..... 0.04
output... 84p
instant salt..0
product code...AL-0
software ......r 1.4
Any help would be appreciated. dont have the money to spend on a service call. but am willing to replace parts if need be. I can solder, run wire and turn a wrench. im not afraid to get in there.
The display said 2500 but there were not any lights lit at all. I starred at it for a few minutes and heard a click and the lights came on for 10 seconds and then went off again. I opened up the box and couldnt see any burn or char marks and i did not see the that the diode was cracked or burnt. I inspected the cord that goes to the SWG and that looks fine and the SWG is only 2 years old.
when i go to the diagnostics:
cell voltage.... 0.04 climbs to 18.0....light come on and then the votage drops back to 0.04 this all occurs after i cycle through the diagnostics, because it defaults back to the 2500 after a minute.
amps..... 0.04
output... 84p
instant salt..0
product code...AL-0
software ......r 1.4
Any help would be appreciated. dont have the money to spend on a service call. but am willing to replace parts if need be. I can solder, run wire and turn a wrench. im not afraid to get in there.