First Test Results. Any Advice?

[superman0604]

Finally got the pool filled, pump running, and a full set of test results. Anything I should keep an eye on or start worrying about?

FC: .5 at sunset (added bleach per pool calculator, circulated, and rested. Now 4ppm)
CC: .0
PH: 7.2
TA: 300 (I tested using 10ml sample so 25ppm per drop and got 12 drops before it changed color)
CH: 300
CYA: 0 (its in the sock soaking, added 3lbs per pool calculator for a target of 60ppm, i'll check in a few days and make final addition)
Salt: 3200 per pool calculator (don't have any test strips for salt, going to start the SWG tomorrow to get it dialed in on run time)

I know my TA is extremely high, add that to the SWG and I know I'm going to have to keep an eye on my PH level (jug of MA ready to go). Anything else I should be focusing on at this point?

 

[elwood58]

You appear to be locked and loaded, as well as prepared to keep an eye on the right things. Enjoy some swim time while you are at it.

 

[linen]

Keep your ph down for now to avoid scaling of the swg's plates. It might be a good idea to drop your TA more quickly: http://www.troublefreepool.com/pool-school/lowering total alkalinity

 

[superman0604]

Keep your ph down for now to avoid scaling of the swg's plates. It might be a good idea to drop your TA more quickly: http://www.troublefreepool.com/pool-school/lowering total alkalinity

What should I try and keep it at? Lower than/at 7.2?

 

[linen]

I would keep down around 7.4-7.2 for now (unless you are in the process of lowering TA, then you will need it to go up with aeration to 7.8, then drop it).