- Jun 1, 2011
- 203
- Pool Size
- 10000
- Surface
- Vinyl
- Chlorine
- Liquid Chlorine
So I was reading my WM bleach that says 6%, reading further down the label it states that it yields 5.7% chlorine. Should I use 5.7 instead of 6 in PoolCalculator?
I did not run the #'s but I am not sure how signifigant this would be.
Also for TA why would calculator say TA should be 70-90+ for TFP specs and traditional is 80-120.
I had TA of 150 with a PH of 8, so I added acid a few days back and my TA is down to 100 and PH came down to around 7.5. I am just confused about that 90+, I thought TA helped to stop PH bounce, so according to that my TA was fine at 150, though PH was not. Gee I feel like I am throwing terms around like I know what I am talking about.
One thing to note my #'s this week I ran were right in line with Pool Stores Electronic tester for most part, TA was off by 10 where they were a little higher, one drop, so that could be my error or theirs.
Thanks
I did not run the #'s but I am not sure how signifigant this would be.
Also for TA why would calculator say TA should be 70-90+ for TFP specs and traditional is 80-120.
I had TA of 150 with a PH of 8, so I added acid a few days back and my TA is down to 100 and PH came down to around 7.5. I am just confused about that 90+, I thought TA helped to stop PH bounce, so according to that my TA was fine at 150, though PH was not. Gee I feel like I am throwing terms around like I know what I am talking about.
One thing to note my #'s this week I ran were right in line with Pool Stores Electronic tester for most part, TA was off by 10 where they were a little higher, one drop, so that could be my error or theirs.
Thanks