I need some help... I'm in the process of bringing back automation to my otherwise manual setup... I've had the EasyTouch 4 system, but the actuators were all bad. The two on the intake/returns were removed and the one for solar only worked if you used the little switch.
I bought two new actuators and was trying just to control the cleaner/skimmer vs main drain valve and solar, instead of intake/return. I plugged the solar one in and when I press the solar button it rotates 180º and when I press it again, it rotates back... I think I can figure out the automation for that...
My problem is, I plugged the other actuator into the valve B slot and was going to set it up so it's automated, but ran into a brick wall. According to the manual, I should be able to do this under the Feature Circuits menu... Menu > F. Circuits
However, I've been through what I believe to be EVERY menu option and cannot find F. Circuits anywhere... I'm guessing I have an old board revision or something. Without screwing around trying to download software, etc, etc... is there any way I can program my automation to work in the manner that I want it?
Also, I guess I should mention, I just installed a new 2-speed pump as well... still ironing out the automation for that as well.
Thanks in advance!
I bought two new actuators and was trying just to control the cleaner/skimmer vs main drain valve and solar, instead of intake/return. I plugged the solar one in and when I press the solar button it rotates 180º and when I press it again, it rotates back... I think I can figure out the automation for that...
My problem is, I plugged the other actuator into the valve B slot and was going to set it up so it's automated, but ran into a brick wall. According to the manual, I should be able to do this under the Feature Circuits menu... Menu > F. Circuits
However, I've been through what I believe to be EVERY menu option and cannot find F. Circuits anywhere... I'm guessing I have an old board revision or something. Without screwing around trying to download software, etc, etc... is there any way I can program my automation to work in the manner that I want it?
Also, I guess I should mention, I just installed a new 2-speed pump as well... still ironing out the automation for that as well.
Thanks in advance!