showing high temp sc60

[sk8er72]

Auto pilot just started showing a pool temp of over 100 degrees when in fact the water is about 80. I have turn the unit of and back on but still showing over 100. also it after turning off and on it show to add 300 lbs of salt but within about 5 minutes it show 3300 salt level. the unit is about 4 years old with about 4 months each year of use. Thanks

 

[Poolsean]

Sounds like a bad tri-sensor connection. Check to make sure it is not loose or that the connector pins have not been bent or damaged. Also, if you wiggle the connector and it corrects the temp reading, then the connector is too loose.