Liquidator upgrade question

[surgdog]

I hope this is not a dumb question. I have done searches and cannot find an answer.

Just got my liquidator with upgrade.

Is there a way to remove the tubing once you attach it to the valves and flow meter? I see it slips in but can you get it out once it is done in case the valves or flow meter need cleaning?

Thanks for a response.

Surgdog

 

[Guest]

Just push the piece closest to the tube in and pull the tubing out, surgdog. It's snug, but it will come out and not hurt anything!

 

[Bama Rambler]

Just to clarify what Bruce said. Those fittings have a release ring right where the tubing slips into the fitting. Press and hold that ring against the fitting and the tubing will slip out.

 

[Guest]

Just to clarify what Bruce said. Those fittings have a release ring right where the tubing slips into the fitting. Press and hold that ring against the fitting and the tubing will slip out.

Much better instructions than I gave; thanks Dave

 

[surgdog]

Thanks, fellas.

I could never find that anywhere.

 

[surgdog]

OK, I did it. Hooked up the Liquidator.

I about had a heart attack when I started it and the pump wouldn't fill. When the level of water got up to the "Out" level everything corrected.

Easier to do than I thought but I felt like I was jumping off a cliff when I had that drill on the pipe.

Still having a few air bubbles through the system but I hope this will all work out.

Checked FC prior to beginning will be checking the next couple of days.

Thanks for answering all my questions.

Surgdog.