I need Hayward Pro-Grid DE filter identification help

[sailman]

I have a Hayward Pro-Grid DE filter that has the following possible model numbers listed on the info decal: DE2420, DE3620, DE4820, DE6020 and DE7220 but none of them are checked so i don't know which I have and therefore how much DER to use. Can anyone identify it from this pic or know what dimensions each one has?

 

[Bama Rambler]

Here you go. Measured from bottom to middle of air relief valve.

DE2420 = 32" -- 3lb DE
DE3620 = 34.1" -- 4.5lb DE Edited to correct model number. Thanks Paul
DE4820 = 40.1" -- 6lb DE
DE6020 = 46.1" -- 7.5lb DE
DE7220 = 52" -- 9lb DE

 

[frustratedpoolmom]

When you were cleaning it, did you disassemble the grids to clean in between them? Sometimes caked-on stuff gets caught in there...

 

[sailman]

I had planned on disassembly but the caked on stuff yielded to my hose stream and washed out the bottom.

 

[sailman]

Thanks Bama Rambler!!!

 

[frustratedpoolmom]

Lucky you!

 

[waste]

Welcome to TFP!!

3600 - eh? Now that it's properly clean and able to properly do it's job, you can keep it that way with my DE filter advice (which can be found here)

 

[PaulR]

DE6320 = 34.1" -- 4.5lb DE

DE3620 = 34.1" -- 4.5lb DE

(picky, picky...)
--paulr

 

[Bama Rambler]

Good catch Paul. I called myself proof reading it to!

 

[dmsalmon]

Here you go. Measured from bottom to middle of air relief valve.

DE2420 = 32" -- 3lb DE
DE3620 = 34.1" -- 4.5lb DE Edited to correct model number. Thanks Paul
DE4820 = 40.1" -- 6lb DE
DE6020 = 46.1" -- 7.5lb DE
DE7220 = 52" -- 9lb DE

Hello. I am trying to identify a Hayward also. Do you mean the bottom of the legs, or the bottom of the filter cylinder itself? Thank you.

 

[440dodge440]

See page 4 of the link for a diagram:
http://www.hayward-pool.com/pdf/manuals/ProGrid-DExx20.pdf

 

[FHMITCHELLXX]

Are those measurements just vertical from bottom of filter to a point parallel with the air relief valve
or are they up the side of the filter and across the top until it meets the air relief valve?

 

[Patrick_B]

Welcome Mitchell

You may not get an answer here with this old thread, so we encourage you to start your own since these old ones aren't always followed very much. Normally I would move it for you first time, but it won't fit anywhere really. If you need the answer please do that and refer to this thread.

 

[!PoolDog56]

How hard would it be to simply attach a sticker or other ID to the filter???