Until my Taylor test kit arrives next week (K-2006), I'll have to resort to using the installers supplied test strips. It was filled two days ago, and the pump has been running since then.
FC 3
TA 80
PH 7.8
I'm assuming these values are OK for now. Can't test CYA, but I asked when they were adding to add lower rather than a higher amount, so he said it should work out to be about 20-30.
At the moment I'm using trichlor in the chlorinator until I get my test kit and switch to bleach.
Does it look like I'm good to go for now?
FC 3
TA 80
PH 7.8
I'm assuming these values are OK for now. Can't test CYA, but I asked when they were adding to add lower rather than a higher amount, so he said it should work out to be about 20-30.
At the moment I'm using trichlor in the chlorinator until I get my test kit and switch to bleach.
Does it look like I'm good to go for now?
Keep an eye on the PH - it is a tad high. When your kit arrives retest the PH and then you can decide if you want to lower it a bit.