I am having my stone sealed next week and the installer says I will need to keep my pump turned off for 24 hours before and after the sealant is put on to make sure the stone stays dry. Is there anything I should do to prepare my water for this? Should I be worried about my chemicals during this time?
Preparing for pump to be off for 48 hours
- Thread starter jk7228
- Start date
- Jun 22, 2014
- 47,790
- Pool Size
- 17888
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- CircuPool RJ-45 Plus
With the nicer weather we've had lately, perhaps not a bad idea to increase your FC level just to help keep algae away. Perhaps ensure pH isn't about to climb over 7.8. The other levels should be fine for just a couple days.
JoeSelf
Gold Supporter
I would raise FC up to SLAM level for your CYA just to be on the safe side, [FC/CYA][/FC/CYA].