Need help with seal kit

[joshua5438]

I am rebuilding my pool pump and need guidance on what all I need. I have the motor apart and the bearings removed and new ones in hand. I need help with the seals needed to put it all back together. Attached is my motor and basket label.

Sent from my SM-G900V using Tapatalk

 

[mas985]

I am not sure what you are asking because the seals have nothing to do with the bearing installation. Just remove the old bearings with a bearing puller and press on the new bearings.

Here is the seal kit but the seal goes on after the motor is installed in the motor plate:

Amazon.com: Hayward Super Pump Complete Pump O-Ring Rebuild Kit, fits all Models: Patio, Lawn Garden

 

[joshua5438]

That is what I was looking for. I was only stating replacing the bearings so everyone would know how torn apart it is and what I needed to reassemble. I also found a water slinger seal, is that needed?

Sent from my SM-G900V using Tapatalk

 

[mas985]

Yes, you can replace that too if needed.

 

[joshua5438]

The one that came off was two rubber washers and a steel washer. Guess the single washer is an update? So that kit above has everything else needed?

Sent from my SM-G900V using Tapatalk

 

[mas985]

Yes but I changed my mind, use this kit instead:

https://www.amazon.com/Hayward-Complete-O-Ring-Rebuild-Models/dp/B00KC0LJJY/ref=pd_sbs_86_2?_encoding=UTF8&pd_rd_i=B00KC0LJJY&pd_rd_r=SJXVV1GY7T83Z2Z8Y5B7&pd_rd_w=b6olM&pd_rd_wg=aglLw&psc=1&refRID=SJXVV1GY7T83Z2Z8Y5B7

It has better seals.

 

[joshua5438]

How can you tell it has better seals? Just so I know what to look for.

Sent from my SM-G900V using Tapatalk

 

[mas985]

It uses US Seal. Crane are also good seals.

 

[joshua5438]

Thanks!

Sent from my SM-G900V using Tapatalk

 

[JamesW]

Deleted.