AutoPilot - Low Volt and Amp Reading

[bobandsherry]

I checked my AutoPilot today and found that the volt/amps reading was 13v 3.1a. Salt level is 3400, temp 85, amperage 696/hr. I had thought that volts should be higher 15+ and that amps should be 5+. Is the current level considered acceptable or should I have PB look at the unit?

 

[Poolsean]

bobandsherry, it should be as you said. However, if it's wired to 110 volts, while the control box is looking for 220 volts, the amperage would be lower than normal. Please have your installer verify the voltage vs the Nano's configuration. If that's correct, contact me for further instructions. [email protected]

 

[bobandsherry]

Thanks Poolsean, PB did a review of the Nano and made configuration change. Now reporting an expected volt and amps.