Circulation Modification

Jun 23, 2016
16
Kuna Id
IMG_20160813_105039663[1].jpg
I used a vacum attachment that was not needed, drilled a hole in it, and attached a 1&1/2 inch 90 degree elbow using a slip fitting on the back side. I didn't glue anything so it can be diverted in any direction. Really really helps the water to circulate with the small pumps that come with above ground pools.
IMG_20160813_105023086[1].jpg
Used in conjunction with a decent skimmer my pool stays WAY cleaner than before. I might mention I use an old panty hose leg around the skimmer basket to catch a LOT of smaller debris before it gets into the filter cartridge. I still check/clean the filter every 2-3 days to make sure everything is clean and I have good water flow.
I used to have to vacume the pool every day or two. Now I can go about a week. I am a bit OCD and can't stand dirt & debris in my water. :snorkle:
 
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.