Just replaced my old single speed pump with an Intelliflo VS pump. I need to program it to run efficiently and effectively. This pump runs the pool only as my cleaner is a Dolphin M4. The pump sits about 3' above the level of the pool.
Programming a Intelliflo VS pump
- Thread starter MRB12
- Start date
Check out this article here: Pool School - Determine Pump Run Time
With an SWG, run the pump for as short of a time period, or time periods split to do so, to achieve sufficient sanitation using your SWG. Higher SWG output for shorter intervals is the most economical.
Welcome to TFP!
With an SWG, run the pump for as short of a time period, or time periods split to do so, to achieve sufficient sanitation using your SWG. Higher SWG output for shorter intervals is the most economical.
Welcome to TFP!
I've got a 12k gallon pool and my pump is about 1-2' above the level. The installer said these pumps can pull quite a bit of head so I don't expect much difference between my setup and yours? Assuming that's ok, here's how mine is set up:
Priming >
Priming time: 0
Priming speed: 2200
Assign speeds >
Freeze: 1000
Pool: 1800
Cleaner: 2250
Waterfall: 1700
Hope that helps!
Priming >
Priming time: 0
Priming speed: 2200
Assign speeds >
Freeze: 1000
Pool: 1800
Cleaner: 2250
Waterfall: 1700
Hope that helps!
Welcome to TFP!
Find the lowest speed that the SWG won't give a flow error and run it a couple 100 more. Mine was 900 rpm so I run mine at 1100 rpm for skimming filtering and making chlorine.
Find the lowest speed that the SWG won't give a flow error and run it a couple 100 more. Mine was 900 rpm so I run mine at 1100 rpm for skimming filtering and making chlorine.
Similar threads
