Hello,
I recently replaced my AquaPure 1400 Tri-Sensor and I am still getting some funky readings. I did notice the tri-sensor was installed on top of the PVC pipe. From what i have read, the tri-sensor should have been installed below the PVC pipe so that air pockets will not get between the water and sensors.
I have attached a picture with the sensor circled in green. Note it is facing "up".
If this is the case, how can I simply "break" the glued fitting and rotate the sensor 180 degrees?
Thanks,
I recently replaced my AquaPure 1400 Tri-Sensor and I am still getting some funky readings. I did notice the tri-sensor was installed on top of the PVC pipe. From what i have read, the tri-sensor should have been installed below the PVC pipe so that air pockets will not get between the water and sensors.
I have attached a picture with the sensor circled in green. Note it is facing "up".
If this is the case, how can I simply "break" the glued fitting and rotate the sensor 180 degrees?
Thanks,