Hello, I am new to this wonderful site. I'm in the middle of one problem where I can't keep chlorine in my pool when I just discovered another problem that mt pressure guage is on 0 no matter what the multi port is on, filter, backwash, recirculate, waste.....all 0
Im in the process of draining and refilling to lower my cya (was 100) to fix the chlorine problem. Most important question I have is can I run the filter even though it says 0? And then of course my next question is how to fix the low/no pressure problem?
Thank ni you in advance for any advice.
Im in the process of draining and refilling to lower my cya (was 100) to fix the chlorine problem. Most important question I have is can I run the filter even though it says 0? And then of course my next question is how to fix the low/no pressure problem?
Thank ni you in advance for any advice.
It sounds as though your gauge went bad. They are fairly inexpensive to replace and an easy DIY project with a small bit of Teflon tape. TFTestkits.com has some very nice glycerin gauges for sale you might like. Nice to have you with us.
