I am having issues with a Breeze SWG and the manufacturer said that high phosphates could be the issue.
I noticed the chlorine dropping, ran the generator for 12 hours and only 1ppm of chlorine was produced and based on the manual it should have produced approximately 4ppm.
I have been adding 10% liquid chlorine regularly to maintain and the pool is and has been crystal clear.
Most of what I have read on this site over the last year that I have had a pool suggests that I should not be concerned with phosphates.
I went to the pool store and tested for phospates and they were +1000, they recommended a phosphate remover and clarifier.
I did nothing. Any recommendations?
My numbers are as follows:
FC 5
CC 0
TA 60
CH 300
CYA 50
Salt 4200(manual recommends 4000-4500)
PH 7.6
I noticed the chlorine dropping, ran the generator for 12 hours and only 1ppm of chlorine was produced and based on the manual it should have produced approximately 4ppm.
I have been adding 10% liquid chlorine regularly to maintain and the pool is and has been crystal clear.
Most of what I have read on this site over the last year that I have had a pool suggests that I should not be concerned with phosphates.
I went to the pool store and tested for phospates and they were +1000, they recommended a phosphate remover and clarifier.
I did nothing. Any recommendations?
My numbers are as follows:
FC 5
CC 0
TA 60
CH 300
CYA 50
Salt 4200(manual recommends 4000-4500)
PH 7.6