After reading previous posts where the power light would not come on, it was recommended to replace the current limiter, RZ3. I did this and the power light came back on with the Generating light on as well. Went back to check on it and now the diagnostics reads p c b and the power light is on along with the no flow, check salt, high salt and inspect cell lights on steady. I installed the resistor the same way as the old one and had taken a picture of my connections to ensure I connected everything the same as before. Any thoughts? Thanks.
Aqua Rite Electronic Chlorine Generator
- Thread starter nazurc
- Start date
- Jul 3, 2013
- 9,028
- Pool Size
- 15000
- Surface
- Vinyl
- Chlorine
- Salt Water Generator
- SWG Type
- CircuPool SJ-40
Welcome to the site, from the manual it says the P C B your seeing that you need to contact the company.. It looks like the fix may not have fixed it.. wish I could help more..
"-Pcb-" displayed and all 4 red/yellow LEDs are illuminated.
A possible Printed Circuit Board fault has been detected. Call for
service.
https://www.hayward-pool.com/pdf/manuals/AquaRite-AQR-Owner.pdf
"-Pcb-" displayed and all 4 red/yellow LEDs are illuminated.
A possible Printed Circuit Board fault has been detected. Call for
service.
https://www.hayward-pool.com/pdf/manuals/AquaRite-AQR-Owner.pdf
Similar threads
