We just purchased a new board for our Aqua Rite System thinking that was the problem with the system. After replacing the old one the lights on the new one will not light up. When you first turn it on the no flow switch flashes and goes off then nothing. Any suggestions on what the problem might be?
Purchased New Board
- Thread starter evanstt
- Start date
- Jun 12, 2011
- 3,763
- Pool Size
- 19500
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pureline Crystal Pure 60,000
The most common issue is the input resistor on the main (large) circuit board. When mine went out the power light wouldn't come on. I just ordered the part from Digi-Key for $2.50 and soldered it in place. Let's hope that someone comes along that knowS more about this than I do.
Similar threads
