Hi All,
I received my new to me Hayward Aqua Solar today and I can't seem to get it working. Here is what I have done so far.
-Installed sensor on inlet pipe by pump.
-put actuator on Jandy valve
-wired Aqua Solar to GFIC circuit
Sounds like I should pretty much be able to set it up from here.
I am wired into 120 not 240, triple checked all good.
Have power to actuator, when I lift the cogs off the micro-switch motor turns valve.
Power going to units as I wired in a light bulb to verify power to unit.
No lights come on to signify power to unit (remember though the actuator gets power)
No test functions ..nothing.
I don't want to go back to the seller without ensuring I haven't missed something stupid.
UNIT IS GL-235.
I really could use some guidance on this one.
Thanks folks,
Rob
I received my new to me Hayward Aqua Solar today and I can't seem to get it working. Here is what I have done so far.
-Installed sensor on inlet pipe by pump.
-put actuator on Jandy valve
-wired Aqua Solar to GFIC circuit
Sounds like I should pretty much be able to set it up from here.
I am wired into 120 not 240, triple checked all good.
Have power to actuator, when I lift the cogs off the micro-switch motor turns valve.
Power going to units as I wired in a light bulb to verify power to unit.
No lights come on to signify power to unit (remember though the actuator gets power)
No test functions ..nothing.
I don't want to go back to the seller without ensuring I haven't missed something stupid.
UNIT IS GL-235.
I really could use some guidance on this one.
Thanks folks,
Rob
Last edited: