Mini board direction for aquapure sensor

[LynnOnTheWeb]

Hi all,

I just unplugged my sensor without first taking a photo. Now, I'm not sure which direction the plug should go in because it works both ways. I unplugged at the black part. Help?

Sent from my iPhone using Tapatalk

 

[LynnOnTheWeb]

Think I figured it out. Seems to have one prong shorter then the others so only goes in one way.


Sent from my iPhone using Tapatalk

 

[JamesW]

Something looks wrong with the white wire connection to the black part. Also, I think that you need to use the little black jumper. Check the software revision and use the jumper if your revision is anything other than 02 11 0A 10. Also, try installing the adaptor board directly to the circuit board without using the extension cable shown in the picture.

http://cdn.lesliespool.com/wpdf/r0537600_installation.pdf

 

[Bama Rambler]

Looks like theirs is the AKC13 front board (figure 4) which requires the jumper. I agree that something looks wonky with the white wire in the jumper header.

 

[LynnOnTheWeb]

Thanks James and Bama. Consolidating this thread with my bad sensor thread at Jandy Zodiac Flow Sensor Bad?

I'll follow up on these issues there.


Sent from my iPad using Tapatalk