swg not working

Last week my Hayward Goldline Aqua-Rite for TCell-15 unit was not displaying anything and all LEDs were off, so I reset the generator by power cycling at the electrical panel and the generator went from a blank screen with no illuminated lights to one that displayed "Err2" with 4 lower right...

New pool (completed May 2023). So all equipment is 3ish months old. Saw some white flakes coming out of the jets recently and figured the salt cell was dirty. We went out of town and my Father-In-Law who was caring for the pool turned off the Chlorinator (chlorine levels were HIGH). White...

Hello, Assistance needed if possible…I have a Hayward salt generator, T-15 cell. Everything works great except for one draw back. When my pump shuts down for the night, my average salt levels drop below allowable generating levels. In the morning with the levels low, my generator indicates low...

Pool 18X12X52 pole pool Intex Krystal Klear SWG rated for 15K gallons Taylor test kit indicate salt ppm at 3200. Chlorine appears to be 0 based on Taylor test kit. pH is good. Is 3200 ppm an optimum salt level or do I need to add more? The filter and SWG have been running for a few days now.

My Pentair Intellichlor IC40 is pretty old. It's bulging and has some minor cracks and seems completely dead (no lights) I changed the fuse 10 amp, power came back for two seconds and smoke came out of unit. I'm guessing it is completely dead? If so should I be good to just swap it with a new...

Hi All, Im a new SWG (cell is new as of this season) pool owner as of mid-august and I've inherited a bit of a lemon... Minor details, I live in STL Missouri and we had horrid flooding at the end of July, former owner got the pool "cleaned" prior to closing but I later found the filter (DE...

Hello! This is our 3rd summer with a 30k gallon vinyl (?) in-ground pool of unknown age in the middle of KS surrounded by cottonwood trees. We had switched it to a SWG our first summer and replaced the sand in the sand filter with ruby sand two summers ago. Other than a few small hiccups, we’d...

I had a company install a pool Fall 2020 that pretty much dug a hole, dropped in a fiberglass form, installed the equipment (Jandy cartridge filter, variable speed pump, and TruClear chlorinator) they happened to have. I arranged the rest, which has been difficult but doable. It was the only way...

Hi there. I have a Jandy Aquapure system with a 1400 cell. Recently, my sensor start reading erratic values. I tested water manually with a TSD tester and salt test strips and read a level of 3.1. The jandy said 4.2 so i did the calibration procedure(held salinity button for 15 seconds) and...

Hi all, First post here! Here is a detailed overview: In Oct of last year (2021) - 7 months ago - I purchased and installed the SwimPure Extreme and T-15 SWG ($1600). I did this because upon removing the cell and trying to clean it, the corrosion would not come off so I figured way not...

Hello! My Aqua Rite system has stopped generating chlorine. The T-3 cell is clean and tested good at the pool store. Device readings: Salt: 3100 (recently recalibrated) Temp: 91 (pool thermo says 88) Volts 27.3 / 27.0 Amps 2.57 / 2.63 Output 100% (usually ~30% but turned up to try to...

Hello. Searching for wisdom. 1000g above ground pool. Intex ECO 5110 SWG generator. Previously posted w issues having earlier this season w error codes. SWG 1 yr old and only 2 months of use last summer. In summary— got 91 repeatedly, so slowly added tons of salt, tested salt and it had...

Hi, CircaPool SJ-20 was working wonderfully until the rain/ lightening storm Monday night. Tuesday morning all red lights again and it was turned off. Flow sensor goes green for 17 seconds then red for 3 1/2 seconds then to green, but then back to red. SWG will not turn on unless flow sensor...