screen logic

Cannot seem to get the connection between outside antenna and inside one to connect and show temp, turn on spa and waterfall, or even show outside temp. I have reset all antennas and made sure all cords are connected properly. the rv and tv on the inside panel do seem to be blinking green...

So after searching, I can find tons of threads about not installing the Lite versions, but what about people stuck with it already. is it as easy as swapping the motherboard to the easytouch 4 or 8? The connectors all look similar so it seems doable. If anyone has a thread of the PSL$ to...

So I recently diagnosed that the control board of my Mastertemp needed to be replaced. It's not quite 3 yrs old and while the 'pool on' light was lit, none of the red ones were, it wouldn't kick on. The lcd screen was blank as well. So our installer brought over a new board. It's the r14...

Hey folks! New to posting but I’ve learned lots of cool stuff here! I haven’t found a post like this but if there is a solution somewhere and someone could point me to it that would be great! So here’s the deal: Pentair VS PUMP and Easytouch/Screenlogic installed. All new pool and system May...

I'm having a lot of trouble installing a ScreenLogic protocol adaptor to my system. I have Gigabit internet and Linksys MX4200 routers. I've spent countless hours on the phone with Pentair and they can't seem to resolve the issue. It seems that the screenlogic is not communicating with the...