replacement

For 1.5 inch replacement hoses, do you have to get the ones branded for your specific pool? I have a Coleman made by Bestway, but seems like stores only have the Intex 1.5 inch hose in stock right now. Wondering if really they're interchangeable so I could go with the Intex or not. Thanks!

Hey TFP, glad to find such a knowledgeable community. Been researching for the past week and had a few quotes built to replace my filter, plumbing and pump. Not to keen on the prices I am a big diyer so planning on doing this myself. You can see what equipment I have in my signature and a...

I need to replace my 20 year old spa jets. One has come apart, and the others don’t spin. I assumed you take them out by unscrewing the knurled ring, but the are stuck and I’m afraid I will break something if I keep at it. Any help appreciated. Thanks!

I just have some questions about the skimmer replacement install today. Took out old cracked ones from my 1980's or older pool. Installed two Pentair Bermuda's. I know they are coming back tomorrow but I dont see any rebar in their supplies/equipment they left here. Do these look like they are...

Hello people of the internet! I have a Hayward Super II Pump, 2.5HP, dual speed (see label). It's about 11 years in service, and I think it's on it's way out - it's getting a little noisy (bearings?) and occasionally does not start - and just gets very hot instead. Right now I can usually let...

Hi All, My multiport valve is leaking through the top where the handle is (3 photos attached). I was hoping to just replace the valve since the PVC plumbing seems good. I searched Amazon and found 1. Pentair 270067 2-Inch Top Valve Assembly Replacement Hiflow Top and Side Mount Pool/Spa...

Hi everyone, I am just wondering how old your pump was before you replaced it? Did you ever fix it first before replacement? For reference we are in Ontario Canada and our pool season is only about 5 months. Our current setup is an old 1980 18x36 pool with 8ft deep end, 1.5" piping two jets...

While setting up we noticed one of the plastic inserts for the horizontal bars was missing and one was cracked. OEM part is not an option due to stock and time, so I was hoping one of you ingenuous people knew of something around the house or hardware store that could be used in place? Is there...

Hi All, My first post, so I want to start out by thanking this forum for it's help! I tried to find answers, but my questions seems semi-specific. Here goes; I have a in ground 18,000 salt water pool. Its 8 years old and the MasterTemp 400 heater is starting to leak. I'm a certain it's salt...

Hello all, I purchased a house with an old pool and a lot of old equipment. I've lived here nearly 2 years and the old pool heater has finally bit the dust. I'm hoping to find something reliable to replace it with, but it seems that no matter how long I search, all of the units I've found get...

The control panel for my salt water pool system had a check cell message so I took my Hayward TurboCell T-Cell-15 to the local pool store to test. They told me it failed the test and to replace it would cost $900. I nearly fell over. Then they told me that I could convert my saltwater system...