pda

  1. Z

    Jandy IAqualink WiFi module with PDA Remote

    I spoke with Jandy by email they have confirmed that it is possible, BUT wont give me instructions only dealers of their products.... Our existing handheld which was on our old controller is Handheld 3.0 Blue Jandy PDA (Blue One) The JBox has a V3.0 sticker the board says 4606. When both the...
  2. F

    Jandy JXI & PDA issue

    Recently had a “ Fault - High Flue” error on my Jandy JXI , bought a new Flue sensor and installed it. Error wouldn’t clear so i cleared it out by holding pool, menu, spa button for 7 seconds, go to load defaults , finished , error cleared. Manually verify heater starts up no errors and runs for...
  3. Exlonghorn

    Jandy TruClear potential problem

    I’ve had my Jandy TruClear installed since 2019, and recently I’ve noticed the FC levels have been down near zero. I increased the pump run time to match the time I was running a year ago and gave it a couple days while adding liquid chlorine. Same problem three days later…FC near zero. No...
  4. E

    Filter Pump Always On!

    Hello everyone, I'm new to TFP, I've been reading some posts but could not solve a current problem I have with my pool. I have a Aqualink RS intalled with PDA (PS4 both on version 3.0) . Thanks to the quarantine I've been looking into the PDA and wanted to make some programs. Apparently filter...