Search results

  1. 20200724_210832.jpg

    20200724_210832.jpg

  2. 20200724_210640.jpg

    20200724_210640.jpg

  3. 20200617_101141.jpg

    20200617_101141.jpg

  4. 20200617_103428.jpg

    20200617_103428.jpg

  5. 20200617_101103.jpg

    20200617_101103.jpg

  6. 20200724_201157.jpg

    20200724_201157.jpg

  7. 20200724_201148.jpg

    20200724_201148.jpg

  8. 20200724_201142.jpg

    20200724_201142.jpg

  9. 20200724_201128.jpg

    20200724_201128.jpg

  10. 20200724_201122.jpg

    20200724_201122.jpg

  11. H

    SWG causing Control system overheating

    Errors in the control system.
  12. H

    SWG causing Control system overheating

    Thanks to my "neighbor" for starting this thread. Here are the details. I have Hayward Aqualogic control system connected to a Hayward Ecostar 3400 variable speed pump. The system uses the board: Hayward Goldline Pro Logic Main Circuit Board GLX-PCB-PRO. I had to replace the board about two...
  13. H

    Help with Hayward Aqualogic System Error ("Pool Bridge Comm")

    Thanks for the response. Sorry for the late reply! The Ecostar pump is on a relay. Do you think it could be a bad or loose wire? The problem seems to happen when it is very hot outside or when the system runs for a long time.
  14. H

    Help with Hayward Aqualogic System Error ("Pool Bridge Comm")

    Just doing a final check to see if anyone has any solutions.
  15. H

    Help with Hayward Aqualogic System Error ("Pool Bridge Comm")

    Does anyone have any ideas to troubleshoot the error messages?
  16. H

    Help with Hayward Aqualogic System Error ("Pool Bridge Comm")

    I have Hayward Aqualogic control system connected to a Hayward Ecostar 3400 variable speed pump. The system uses the board: Hayward Goldline Pro Logic Main Circuit Board GLX-PCB-PRO. I had to replace the board about two years ago. Over the past 10 months I have been getting various error...
  17. Pool Bridge Comm.jpg

    Pool Bridge Comm.jpg

  18. Low Link.jpg

    Low Link.jpg

  19. Comm Error.jpg

    Comm Error.jpg

  20. H

    Aquarite Board Problem - Clicking Sound

    I have a Hayward Aquarite system running my Houston saltwater pool. I am getting a "clicking" noise from the main board. It sounds like a relay is going on and off or there is a small power surge. The board is Hayward Aqualogic PCB-Main. Here is a short video of the noise: Wait about four...
  21. H

    Help me diagnose: Low flow after installation of new pool heater

    At higher speeds, the pressure has gone up, but I don't thing the pressure has increased at the cartridge filter at the same speed I used to run the pump.
  22. H

    Help me diagnose: Low flow after installation of new pool heater

    I just replaced my pool heater that was about 10 years old. It was rusted beyond repair and I replaced it with a smaller, more efficient model. I had a Pentair 400,000 BTU heater that hadnot worked for almost a year. I had a pool company install a Pentair MasterTemp Low NOx Pool Heater -...
  23. H

    Hayward Ecostar 3400SVP pump Drive Error

    Thanks, mas985. I just sent a PM.
  24. H

    Hayward Ecostar 3400SVP pump Drive Error

    I just read this thread about the "Drive Error Pump Has Stalled". Yesterday I had the same issue and the pump would not start. I didn't find anything in my pump pot and have also tried powering off the circuit and have had no luck in getting the pump to prime and start. This is a relatively...
  25. H

    Hayward/Goldline Wireless Mounted Remote Controller compatability

    I currently have a Hayward Goldline AQL-WMW-RF-PS-8 Wireless Wall Mounted Remote Controller like the one pictured here: Hayward Goldline aql WMW RF PS 8 Wireless Wall Mounted Remote Controller New | eBay The power supply on the back has detached rendering the unit useless. I am looking for...