Search results

So I have 6 Hayward Colorlogic 320’s hooked up to an OmniLogic through Hayward transformers. I keep loosing lights every 8 to 12 months which is getting really expensive. They just start ramping up and down and lose some colors. Not all the lights die at the same time. I don’t want to believe...

A couple of months ago I started loosing chlorine at a faster rate than usual so I performed an overnight test which failed. I followed the SLAM procedure and everything went back to normal. This weekend we had a storm. I checked my FC before the storm and I was at 7 PPM with a CYA of 70. During...

Ok. So I have done a bit of reading here on balancing my pool water. There is one thing that confuses me though. For a plaster pool with a SWG, the recommendation here is to have a TA of 60 - 80. Is that recommendation after calculating to remove CYA? My readings from my Taylor FAS-DPD kit are...

Hi everyone, Thank you for all of your help so far. I have another question on my OmniLogic that I cannot seem to figure out. I am having trouble with my heater schedule. I can turn my heater on and off manually from the omnilogic and change set points. But no matter what schedule I set in...

Hi, I am running an Omnilogic, and I have a question. On my Returns, I have an automated valve which the cams are set to throttle when I turn a feature on. Because I don't have a schedule on the valve though, when I exit a theme the valve goes to a throttled position which is not great for...

For anyone that has configured an Omnilogic, I have a question. On a new build, do I have to wait until my pool is full to power up and start configuration of the panel? I wanted to start the configuration early, but I am not sure if it is ok to do so. Does anyone know? Thanks for the help! Troy

I am planning a 10 X 10 Tanning Ledge and am trying to figure out the best way to light it. I am going to do one or two Colorlogic bubblers on the ledge. So I am wondering if the bubblers are off will turning on the lights for the bubblers light up the ledge properly? Or should I put a...

Hi. I am thinking of putting an Omnilogic in my new build, but have questions for anyone that uses it. 1) Can I program it to close the Bottom Suction Valve, Skimmer Valve and open the cleaner valve when I want to clean? 2) I was looking through the programming and I saw in the setup for heater...

Hi, I am in the planning stages of a new pool which will be about 15,000 Gallons. I am planning on having one bubbler on a shelf, two laminars and about 36" of sheer. I am also planning on using a Hayward Ecostar. This pump will be for main return jets and waterfeatures. Should I use a three...