Search results

Ok guys. I thought I was done but it seems like I have one last issue I can’t figure out. I have an Intelliflo VSF pump. I have the communication cable wired to my Aqualink Power Center. I am able to fully control the pump from the iAqualink app. I can change speeds, turn it on and off, etc...

I have a Jandy LT 400k BTU Gas heater. Installed back in 2005. I've had issues with it over the years that I've been able to troubleshooting and fix. The last one was the GUI needed to be repaired. I sent it out for repair. Everything worked great for a couple of seasons. Last year, I went to...

My pool has the Jandy Aqualink RS power center and controller. Still working but the PDA no longer works. I would like to replace/upgrade to one that uses a phone app. I noticed there is an Aqualink 3.0 that I can find online but I don’t know that it will work with the Aqualink RS version I...

We are considering adding a pool cover. Primary reason is to keep our Frenchie from drowning should he fall in if unsupervised. Is not allowed out back without someone but you never know. I’ve seen the tension-type covers but our pool deck has differing elevations so unsure if this is an...

Hey all, I've searched the forum but didn't find any similar threads with an outcome. I have an Intelliflo 3HP pump. I don't recall the version but it's at least 6 years old. Earlier in the week I noticed the pool was not running. Checked the pump and no worky. Display is blank. I've ruled out...

Hello everyone. I fired my pool guy right before winter. Long story. So I've had the job ever since. After some epic battles with algae and chemistry completely out of whack, the Pool looks better than it has in several years. Lot of credit goes to the FAQs and reading posts on this forum. That...

Hey all. Been a while since I posted. Need collective brain trust again. I'm trying to revive my Jandy LT400 heater. It's not powering up. I've done the troubleshooting and it leads to a faulty Temp Control board. Unfortunately, this part is now obsolete and there is no replacement, as far as...

My Jandy 60 sqft DE filter needs to be replaced. I'm getting small leaks around seem. I've replaced the o-ring and metal collar but it still leaks. I'm assuming the plastic case has lost its shape after 12 years of the sun beating down on it. My question is, are all DE Filters equal when it...

Pump is about 4 years old. Runs great. The issue I'm having is that it won't run at the RPM I have programmed. Maybe I am doing something wrong. The problem began when I changed the programming. I have all but speed 2 set on manual or disabled. Speed to have programmed on a schedule to run for...

Will a leaky filter case cause this? Noticed this morning that my DE filter was leaking pretty at the main gasket join. I opened it up and noticed that the lower half of the grids had no DE stuck to them. Exactly where the bottom half of the filter connects to the top half. This leads me to...

Hey all. You guys have helped solve some heater problems in the past so thought I see what you guys say about a problem I have now with my DE filter. The darn thing is spewing DE back into the pool. It was real bad last weekend. I replaced all the grids. One of them had a tear but all had...

I have a Jandy LT 400 BTU Gas Heater. It's about 11 years old. It won't start. Here is a quick sequence of events: Power up the heater. Light on the panel comes on. About a minute or two passes with nothing happening. No blower, not nothing. Service and ES-1 light comes on. This heater is...