Search results

  1. L

    SWG size help....

    Can I use this for my friends 10500 gallon pool? CircuPool SJ-20 Salt Chlorine Generator good for 20000 gallons or should I increase to the 35000 gallon size. That is the next available size for $1 more at this vendor. Seems like really killing and ant with a sledgehammer.
  2. L

    Help with Hayward multi port

    Not sure if this is the correct area to ask but... I need to rebuild it, I'm sure I can but I have found the spider gasket has to be glued in. What type of glue ? Regular PVC glue or something else? Thanks Rich
  3. L

    Need to replace the coping...

    I have a 13 year old deck of Nicolock Pavers. Olde Towne 5 piece in adobe. (sort of tan to a light brown). The bullnose has deteriorated where a lot of aggregate is showing through, but most importantly a few need to be replaced. The problem is that are not made any longer and getting the same...
  4. L

    Advice needed...

    I have a 20 x 40 IG. Had a huge problem with a liner repair the year before. That was finally cleared up and last year we enjoyed a trouble free pool. I have 2 Blue Latham roman stairs installed on opposite short sides. The pool was built in 2006 and never had any real problems at all until the...
  5. L

    Compupool about 6 years old

    The cell is leaking from all over. Wires loose at the cell. Needs to go. Can someone recommend a decent budget friendly for a 22K gallon in ground pool. Its for my 80 year old stepmom. Gotta say the compupool was a budget one but well well enough for the 6 years it was in. Any help would be...
  6. L

    Pool Pilot SWG replacement part question

    Went out to the pad yesterday and noticed the door to the control unit blew off over the winter. The main white cover is fine the only problem is the door broke off. I see someplace sell a whole cover replacement for around $110 . I only need the door part though, anyone know if that is...
  7. L

    2 skimmers to replumb

    So I decided to replumb the 2 skimmers on my 20x40. Presently they are leaking somewhere, and I only take a plug out of one to vacuum. They are connected via a T, And since I am re doing them is there an advantage to piping 2 separate lines back to pump or can they be T'd like they are now. I...
  8. L

    Hayward Stair jet SP1434PAKA leaking

    I really don't use it much but will a problem to cap off. Would have to remove pavers and concrete underneath to expose. I found a Hayward part that says it is a test plug SP1434TP. -Does anyone have any experience with this part ? -Can it be used to permanently close this off ? -Can I glue it...
  9. L

    So my nightmare continues..

    After my liner change disaster it seems I have a leak. I have been losing a lot of water quickly. It drops about 2" per day until it hits near boom of the skimmer. Then pretty much stops. The new liner guy came out and did a dive to check out all of the cuts into the line. The 3 returns, main...
  10. L

    Pool Fill

    Generally how long does it take to fill pool after liner change. 28000 gallons. I also have 4 hose bibs around the pool. Suffolk County Long Island.
  11. L

    Liner replacement Disaster

    Contracted with a pool liner replacement company in November of last year, still no liner. Low life company owner kept telling me he had to re measure , delays due to rain, and the new liner is coming in soon, busy on other jobs, blah blah blah. Finally decided about a week before the 4th of...
  12. L

    New liner questions

    Long Island house IG 20x40. 3.5' -6' deep. The bottom of the pool is sand filled. Contractor says options are : -simple liner change -troweled bottom for hard floor. The hard floor obviously cost more-about $1000. Says benefits include no dents from feet. Looks better at night. Could cost more...
  13. L

    Need a new in ground liner

    Anyone have any recommendations for Riverhead NY. Would be in Suffolk County Long Island. Thanks rich
  14. L

    hayward de 4820

    Not sure if this is the appropriate place to post but.... I need a new band for my hayward de 4820. Anyplace I can get a used one cheaper than the approx. $200 for a new replacement? Thanks Rich
  15. L

    I use borax and need to adjust ph up

    My borate level is about 40 already and my ph is 6.8 after massive rain storms. Pool calculator says to add 201 ounces of borax to correct. Will this mess up borax level to high or should I use something else to raise ph? ph 6.8 FC 2 CC 0 CYA 60 TA 75 CH 190 Vinyl pool. Shocking in...
  16. L

    Best SWG recommendations

    What is the best for a 28000 gallon pool? Preferably one that has a low flow requirement. Thanks
  17. L

    PLEASE HELP !!!!!! Away for week found this

    Last week perfect, ph 7.5 fc 3 cc 0 cya 60 SWG 50% this week cloudy water as of yesterday afternoon Jandy SWG showed no flow I don't know why. No error codes, I have since reset it and recalibrated it and it seems to be working. However test results are as follows ph 7.5 FC 0 CC 3.5 CYA 0...
  18. L

    Pentair VS pump question

    I thought I might have seen somewhere on this forum about trying to keep the pump protected from the elements, notably rain. Is there any need to have the pump protected from rain. I know it's a pool and water is around but is it necessary to build a cover for it. Thanks
  19. L

    Hayward de 4820 with de inside the grids again.

    It is inside the grids again. Happened when I opened the pool, and not knowing if the manifold was broken or if there was a tear in the fabric I got a great deal on a new filter. Is it possible that the multi port valve is not working right and directing the water into the grids and not outside...
  20. L

    piping in a pentair vs pump

    Is there a preferred fitting for the initial fittings on this pump? I know some web sites recommend the pentair union, buy I was wondering what else can be used. The rest of my piping is 1 1/2". If I use a 2" nipple into/out of the pump instead of the union I can put a 2" coupling on the nipple...
  21. L

    pentair vs question

    On the pentair VS pump do I have to buy their special unions for the install?
  22. L

    Need help with a new pump selection

    Installed a hayward ecostar SP3400VSP about a month ago, it blew this week, totally fried, I dont know why. The fantastic folks at poolsupplyworld graciously will take it back since it is impossible to service locally. I get it, I didn't buy it locally so they are to busy to help me. Wanted me...
  23. L

    Compupool cpsc 36

    Got a brand new one and the LCD board is bad. They want me to change the board. Is this normal? Is this a common problem? Thanks Rich
  24. L

    Hayward SP3400VSP priming question

    When starting up it fails to prime when in auto detect.
  25. L

    compupool cpsc36 problem

    It was installed and all water chemistry is just about perfect. However all lights are on and it doesn't seem to generating chlorine. I had to convert it to 110v and that was not a problem. I saw a post from poolsupplyworld that when you convert to 110 sometimes the internal fuse has to...
  26. L

    Latest test results should I adjust CH

    Ph 7.6 Fc 4 Cc .5 TA. 80 Cya 75 CH 20 Compupool SWG 22000 gal vinyl in ground Thanks Rich
  27. L

    My dads pool

    Following test results with tftest kit: Ph 7.2 FCC .5 Cc. 0 TA 70 Ch 20 Cya 37 Salt 3000 Just converted to salt. Ready to turn on. Any suggestions Thanks
  28. L

    Compupool cpsc36 salt question

    I installed it for my father last week, getting ready to have him add salt while I am away. Is the salt level 3000ppm? Thanks Rich
  29. L

    Trying to adjust FC with new equipment

    Changed over to a variable speed pump
  30. L

    My fathers pool

    For the first time I opened his pool, or at least tried. 22000 gallon IG took cover off found a dead possum on bottom, water looked kinda clear though. Used the test kit to try and get some preliminary numbers. I didn't have enough time to to let the pump run for a while but I got these...