Search results

Yesterday I notice a flashing green light to check cell. When I opened it up there was a good amount of calcium build up which was surprising since I just cleaned it a little over a month ago. I cleaned it again and started up with all lights showing green and no flash. Since I had no...

The heater is set for a spa temp of 99. When we turn on the spa the heater control panel shows the water temp jumping erratically well above 100 even though the pool temp is only 86. No service lights are showing and the panel shows the spa on. I went through the troubleshooting check list...

I noticed this morning my actuator valves did not rotate back to the pool after using the spa last night. I have an Easy touch control panel which shows it to be in pool mode but the valves remain switched to the spa. I tried to switch the valves over using the manual toggle switches on the...

I posted this on another forum but as of yet not gotten much help...Hopefully you guys might have an answer. My pool and attached spa are controlled with an EasyTouch 4. The last week my pump has been cycling off and on every 15 minutes requiring me to reset. I had this problem in the past...

I currently have an EasyTouch control without the IntelliChlor option. If I purchase an IC40 do I need the complete power center or do they sell components that will fit in the ET box? I also have trouble with water hardness, should this be a concern with the life expectancy of the generator...

I just came upon this forum while googling SWG. I'm planning on adding an Intellichlor to my pool in about a week but want to make sure all my ducks are in a row to prevent any problems with the install. I live in No. Calif. My pool is a 30 yrs. old in-ground fiberglass over gunite. I...