Search results

  1. A

    Leaving Active 20 in Pool Full Time

    I did a search and seemed some do leave robots in 24/7 except when swimming. My pool is really only used weekends so I would love to leave it in and have it do a clean Tues and Friday...that way Saturday morning pool is ready to go and I just have to pull it out. Is this feasible? After...
  2. A

    Repair Polaris 9350 or Buy New

    I have a 9350 that is probably 4-5 years old. I have had no issues until this morning when I noticed only 1 wheel was turning. Pulled it out of the water and it seems that side is toast. I can freely turn the wheel that was working but the right side is frozen. I can replace the motor assembly...
  3. A

    Aquarite with T9 and Salt level of 4500

    Newly installed SWG. I did calculation based on 11,500 gallon pool which would of been roughly just over 300lbs of salt to get pool started I put about 260 in and checked next day to be sure I didn't overshoot...well I either have a smaller pool than I think or I suck at math but I am now at...
  4. A

    Polaris 9350 Cleaner

    I have had one for couple years now and probably spends more time in water than it should. No issues so far with it but want to keep it humming as long as possible. Occasional seen horror stories about leaking seals and damaged circuit boards... Is there any preventive maintenance that can be...
  5. A

    Aquarite Install plumbing question

    I am installing this weekend and I see the need to have 12" of straight plumbing before the flow switch but is there a minimum distance needed before water enters the cell. My current setup has a 90 degree turn about 12" after exiting the filter then a longer run before another 90 degree turn...
  6. A

    Heat Pump Usage in SW FL - HP selection and estimated costs

    I have to measure, but I believe our pool is 10-15k gallons in SW FL. My last pool we had solar which was nice, but certain times of the year wasn't quite enough to keep the pool an enjoyable temp. We also had horrible roof issues, so between the two I am hesitant to do solar again. I am...
  7. A

    Vacuum vs Booster Pump cleaner and converting plumbing

    I currently have a 3/4 HP pump with a suction cleaner attached directly at the skimmer (just moved so equipment in sig is wrong) also have a Skim A Round skimmer attached between the skimmer and cleaner. Problem is, not quite enough suction to run both....so once a week before work I turn...
  8. A

    New SWG Suggestion

    I am buying a house with a roughly 15k gallon pool. Will have a superflo vs pump connected to an Intermatic timer. No spa, no heater, pretty basic setup. With no real need for automation, what SWG would be a good choice. In my current home have a AquaRite cell and controller. I had to replace...
  9. A

    Wiring a Z Wave Switch to Intermatic X100

    I have an Intermatic X100 currently that goes to my pool light and controlled by a RC613 but when we bought the house the remote had been lost and it's in a very inconvenient location. I found a GoControl zwave switch GoControl Z-Wave Isolated Contact Fixture Module - FS20Z-1 GoControl Z-Wave...
  10. A

    New Equipment selection and install advice needed

    I have a roughly 15 year old pool with all original equipment. It sits in the FL sun and it's worn out. I have at least 2 leaks, one of which is from the pump and I want to replace the filter, pump, and all pad side plumbing. Currently I have a 1.5 hp Whisperflo pump, Triton II sand filter...