Booster pump and salt cell plumbing.

Jump to latest Follow Reply
R

Rcstorm

Member
May 31, 2021
10
New Jersey
Hello,

I am going to be plumbing in a salt cell to my set up and am wondering if it is a problem to have the booster pump plumbed in after the salt cell? It would simplify my plumbing. In the picture below I would like to add the T for the pump on the vertical side of the elbow on the supply from the filter.

If that is a bad idea any suggestions on how to plumb after the filter to accommodate an IC40 and the booster pump?

Thanks.
 

Attachments

  • EE16C3F6-2362-4424-A0E8-C7C155E754EC.jpeg
    EE16C3F6-2362-4424-A0E8-C7C155E754EC.jpeg
    543.4 KB · Views: 13
I would do a vertical kit and install just after your booster pump, go up and back down into the existing plumbing.. Cut 1.5 inches past your booster pump, install a 90 degree going up and go from there.. Cut of the 90 where it goes into the ground and connect the other end when done.. I would put the flow meter before the booster pump right in the middle.. :)

1649871032328.png

This is the circupool one but it is same idea for yours..

1649871274222.png
 
That one is for curcupool and has different threads than yours... I could not find one for Ichlor SWG..
 
Last edited:

Enjoying this content?

Support TFP with a donation.

Give Support
You must log in or register to reply here.
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Top Bottom
Back
Jump to latest Follow Reply