Recent content by Wooderson72

TA usually sits at 70. May creep up to 80, but that's it. It seems that 70 is the sweet spot, and I've never seen it get below that. Fill water TA is 110. Sounds like it's better just to get the ph to 7.6.

When I add acid, I usually add at about 7.8 ph or so, and get it down to about 7.3, or low enough where it does not cause CSI to get too far in the negative. I've noticed that the next evening when I test for ph, it has jumped to 7.5 or even 7.6. Then it will sit between 7.5 and 7.7 for...

Ok, thanks for the response!

Ok, thank you. On the CYA test I lost the dot right between the 40 and the 50 so I was considering it 45ppm. At what point should I be concerned my CH is too high? When it hits the top of the recommended range (650)? On average does it take quite a bit of time to climb? I have been and will...

I suppose I should mention I am using liquid chlorine and not tablets, so no CYA addition there...

My CYA is currently sitting at 45 and my CH at 400. Will these numbers trend up or down with splash out and fill water? My fill water has a CH of 80. I'm just wondering if I should expect these numbers to increase or decrease over time. I would think the CYA would slowly go down, but the CH...

That is the reassurance I was looking for, thank you.

First time pool owner, went with the blue granite pebble sheen finish. The pool builder, who otherwise we have been very happy with, classified pebble sheen and plaster as completely different finishes, which I understand, but he then basically told me there was not any plaster in my pebble...