Recent content by wkk2

  1. W

    IC20 LEDs go on only during power up

    The "More" button doesn't seem to do anything (display stays dark). The filter is some type of Clean Clear. The model tag is damaged so I'm not sure of the type. There are valves on both sides of the IC20. One diverts around the heater and the other between the Spa an Pool. I hope there is...
  2. W

    IC20 LEDs go on only during power up

    I can only guess on the cell age. The IC20 is on the ground so I can't see the serial number. The seller left a dead unit in the garage that was 2011. If it lasted 5 yrs, the new is 3 or 4 years old. The pool is about 10k Gal. I'm assuming it's easy to replace. Pump off, maybe drain...
  3. W

    IC20 LEDs go on only during power up

    Due to rusty screws I couldn't get to the Red/Black PCB termination points so I made an external tap cable with a Male and Female connector from a dead unit. The voltage going to the IC20 is 41V and is constant before and after the LEDs go dark. There is about 20mV of ripple. It seems like...
  4. W

    IC20 LEDs go on only during power up

    I'm a new pool owner. The IC20 was showing low salt. Salt was added now all the LEDs are dark. The LEDs light and two blink for a short time after main power up then they all turn off. The LED in the transformer box stays on. The Easytouch panel shows OK but changes to COM failure after a...