Texas Splash's latest activity
-
Texas Splash reacted to Vonswoopington's post in the thread Brown stain between stair line tiles with
Like.
Update: The plaster warranty folks will drain the pool and fix the issue. They'll be done by the end of the week so I'll post updates of... -
Texas Splash replied to the thread New Pool & Home Owner.Welcome! :wave:
-
CYA is closer to 40 than 30 so I am increasing my SLAM level to 16. I was targeting 14 this morning and FC is already down to 12...
-
Filtration removes dead algae. If it's green then the problem isn't filtration. Mustard algae is yellow and clumpy. A green pool is...
-
Texas Splash replied to the thread Green Pool after 3-days of SLAM.24/7 yes, but doesn't need to be on high speed. Consistent, steady water movement through the filter and pool is what is most important.
-
Texas Splash replied to the thread Green Pool after 3-days of SLAM.Ooooooh, that's quite soupy. It's going to take a bit, try to be patient and consistent with the FC testing. If you believe the CYA is...
-
Texas Splash replied to the thread Green Pool after 3-days of SLAM.Could you post a pic or two of the water?
-
Texas Splash replied to the thread New pool.Welcome to TFP! :wave: The link below has a lot of great resources to assist. Good luck with the build.
-
Texas Splash replied to the thread New and starting out.I wouldn't waste any time or energy on those test strips. Even if they were brand new they wouldn't be helpful. Think of it this way...
-
Texas Splash reacted to 1poolman1's post in the thread Pump not priming and motor making noise with Like.
Do not be surprised when that motor gets very loud. You can see the corrosion at the front of the motor. The seal has leaked for quite a...
-
Thanks for your reply 🙂 I'll hold off on anything other than chlorine for now. YouI wasn't able to find the 2006C but I did find this...
-
Texas Splash replied to the thread New and starting out.Yes, that will work. :goodjob:
-
Texas Splash reacted to medic502's post in the thread Pump not priming and motor making noise with Like.
Thanks... It finally primed and pump is working. Yes, I do have a leak. I will replace shaft seal.
-
Texas Splash reacted to JamesW's post in the thread Pump not priming and motor making noise with Like.
Sounds like bad bearings and maybe a voltage issue. Maybe a broken off impeller.
-
Texas Splash replied to the thread New to TFP.Welcome! :wave: