Recent content by riverlvr

The company name is TE.com , part # for plug is 770759-1 (08P MINI UMNL PLUD HSG) , the pin socket part # is 1-794407-0 ( MINI UMNL SOK 20-16 AWG AU LF) they also showed the connector for the circuit board, however I did not need that as I had purchased a new board. Crimper was from Amazon...

Ok, so my new plug and connector pins finally arrived. I also purchased a crimper for the connectors and clipped the plug off the power box, installed the new connectors and slipped them into the new plug housing. Installed with die-electric grease and all appears to be normal again. Systolic...

So, my update is, after a couple hours searching on the "Google" I am waiting for connector parts to arrive to replace the connector in the Ph box to circuit board. As I stated before I have a new circuit board. I am going to use dielectric grease on the contacts after replacement and see where...

Ok, here are some pics.

This will be the 3rd time over approx 4 years that the connector from the power supply to the IntelliPh circuit board overheats and melts. I have had this occur not only on original unit but replacement (complete new unit). I have also replaced 1 control unit separately. The overheated pin in...

You might try MarineTex. It is an amazing product that is the strongest epoxy product I have ever used!! Saved my butt numerous times. Can be used with additional fiber mat too.

Ok, thanks. I'll give Leslies a shout and see what they have to say. Thanks again and I'll post the outcome. Jim

Me Too

So the plot thickens eh? What is involved in re-flashing/updating firmware?

Here ya go.