Recent content by pooldadd

Hi everyone. My pool was built in 2013 with Savi Melody S lights (at least I think they are S based on the year). My controller is an Aqualink RS with an iAqualink. The lights have slowly gone out over the last couple of years. I assume I need to replace all the cartridges. Is it possible to...

Thanks! As for actually replacing the sensor, will it come with instructions or what is the best source for how to do it?

My Jandy Legacy heater is not working, and the display shows "Fault - Shorted H2O Sensor" and "Water:212o Set:104o". I understand that means that the temperature sensor is bad and needs replacing. It's a salt pool and the manual lists two parts: R0477300 (salt) and R0456500 (regular). I tried...

Yes, the fitting stays there. The Polaris hose pushes in and twists to catch on. As for the return pipe, how far in should threading go? Does the pool builder typically thread the pipe themselves (and didn't go far enough) or does it come pre-threaded? Here is a better picture of it: Maybe...

Thanks for the welcome. We like our new pool, and I realize there are certainly worse things that can happen! It's one of these things that doesn't screw all the way in. Came with our Polaris 280.

Hi. I'm a pool "newbie" and just noticed that the Universal Wall Fitting does not screw all the way in the return line on my new pool. It sticks out and there's more than a 1/4 inch left to go. The cleaner plugs in and works fine, but to me it looks bad and could be a hazard. My builder said...