Pool Clown's latest activity
-
Pool Clown replied to the thread Pentair Load Center Low Voltage Transformer Wiring.Switching it to 120V is pretty straight forward. You just use a different wire. The hookup diagram should be printed on the door inside... -
Pool Clown replied to the thread New plaster and tile problems-any ideas welcome.First pic, That is typical plaster modeling that occurs in all plaster. Yes, some more than others. Some causes are, but not limited...
-
Pool Clown replied to the thread Bad Plaster on New Pool?.Some thoughts... The acid wash looks to be a very light one. Good and bad. The good is, a light wash doesn't etch the surface as...
-
Pool Clown replied to the thread Removable- temporary handrail.And that also applies to no hand rail at all... Which brought us here to this thread in the first place. Sometimes, there is just no...
-
Pool Clown replied to the thread Removable- temporary handrail.Handrails are increasingly becoming sources of liability. Especially this type that does not get secured into the anchor with an anchor...
-
Pool Clown replied to the thread Can hydrostatic valve be closed?.We would make our own out of 1 1/2" PVC pipe 12" to 16" with an FIP fitting glued on to one end then screw in a threaded plug. Leaving...
-
Pool Clown replied to the thread Need advice for pool light.The pool industry has always been behind when it comes to new technology. LED lights are no exception... LED lights for pools are still...
-
Pool Clown replied to the thread Problems with Aqualink.Does it lose the info without a power interruption? or only when you lose power? The Battery is just to keep info when you lose power...
-
Pool Clown replied to the thread pentair 400 touch pad doesn't work , spa light and service light on-heater wont start.Spa light on means that thermostat is currently active. Which service light? Service Heater? or Service System? Service heater light...
-
Pool Clown replied to the thread Best way to clean rocks from pool from neighbors pool build that rained gunite shrapnel in my backyard.If you are careful and have your pumps' pot basket in place, and is not cracked, there is no reason why you couldn't vacuum that up with...
-
Pool Clown replied to the thread Can hydrostatic valve be closed?.You should probably get the type of valve that is spring loaded. IOW, it works when it needs to. If you were to be a full time...
-
Pool Clown replied to the thread Pentair Mastertemp 400 manifold.Sounds like you need a new tub and lid (#15 & #20) Mastertemp install and user guide page 51 and 52.
-
Pool Clown replied to the thread Pentair Mastertemp 400 manifold.Im a dope! thought it was the bottom. I think either the seal was not good from the factory, or like James suggests a later repair that...
-
Pool Clown replied to the thread Pentair Mastertemp 400 manifold.I think If there was some kind of an obstruction with the venting, the Stack flue switch (SFS) would trip. I believe the heater is...
-
Pool Clown replied to the thread Pentair Easy Touch breaker swap help.Yes, if you "Daisy chain" GFI's, you will get either no workie, or always tripping GFI. Neutral for GFI's must be exclusive to one...